Die dimension checker | ACS Material

Do the dimensions of this die fit this press?

Choose a PressPro™ press and enter four dimensions of the die. The check compares them with the worktable, the workspace between the columns and the piston stroke printed for that model. It is a dimension check only.

Press model

Die outer diametermm

Assembled height, plunger resting on loose powdermm

Compaction travel of the plungermm

Ejection travel (pellet plus one anvil; 0 if the pellet stays in a ring)mm

base and top platecolumns and worktabledie, within the dimensionsdie, outside the dimensions

Dimensions only. A die that fits is not thereby rated for the load: the force of the press and the pressure limit of the die are separate checks. On manual frames the lead screw at the top takes up the height between the plunger and the top plate, so the hydraulic stroke is used for pressing and, on a second setting, for ejection.