Polytevo Series tools

Batch and material budget calculator

Type your own assumed numbers to see how many cycles, how much material and how long a planned run a target quantity needs. Three separate calculations are offered: cycles for a target of usable material, a planned running interval for a continuous route, and the mass of a chamber charge from volume, fill and density. The fields start empty. Nothing is converted between a mass per cycle and an hourly rate, and the calculator never gives a residence time. The calculation runs in your browser; nothing is sent.

Target

Cycle (batch) route

g
g
min

Continuous route

Chamber charge

mL
%
g/mL

Use consistent units. Enter decimals with a point or a comma, for example 0.5 or 0,5. Values such as 12,5 and 0,500 are read as 12.5 and 0.5; 0,500 never means 500. Multiple commas in complete three-digit groups mark thousands, as in 1,234,567 or 1,234,567.5. For an entry such as 1,234, your browser’s number format determines whether it is read as 1.234 or 1234. The field states which value was used. Inputs must be between 0.000001 and 1,000,000,000 in the selected input unit, with zero permitted for loss. Accepted decimal precision is limited to 12 places after exponent expansion and removal of insignificant trailing zeros. Fill cannot exceed 100%. Cycle counts, derived mass quantities and estimated charge mass are limited to 1012; mass quantities are expressed in grams. Total cycle time is limited to 1012 minutes, and continuous runtime to 1012 hours. These are numerical limits, not physically recommended operating ranges. An empty optional field applies the stated assumption (no loss, no cycle time); an invalid optional entry blocks the result it belongs to.

Figures published on the Polytevo pages (15 November 2026), for reference

These figures are displayed for reference. Each keeps the label the page gives it. A capacity, a mass per cycle and an hourly rate are different quantities, they are not converted into one another, and their definitions are confirmed on quotation. Use a value in a calculation only after its definition matches the input required by that calculation.

PagePage label or wordingFigure as published

Arithmetic only: n = target usable material / (assumed input mass per cycle - assumed loss per cycle), rounded up exactly at the precision you typed; running interval = target usable material / assumed usable-output rate; charge = volume x fill x density (one material-state basis). These are planning quantities for a material budget. They do not describe how long material stays in a machine, and they do not predict what any machine will deliver. Specifications are as published on each product page, and final configurations are confirmed on quotation.