How much force does a specimen need?
Enter the width and thickness of the narrow section of the specimen and your estimated peak engineering stress, based on the original area. The screener multiplies them and compares the force with the load-cell capacities printed on the Polytevo Series Universal Testing Machine page. It is a screening aid only.
Your numbers
Rectangular initial cross-section only: area = width × thickness.
Result
Force F = estimated peak engineering stress × original area, with stress in MPa (N/mm²) and area in mm², gives newtons.
Display rounding does not establish measurement precision or test validity.
Caveat. Screening only. The force follows from the estimated peak engineering stress you assume, based on the original cross-sectional area (not true stress), and not from a prediction for any material; a reported strength value need not identify the peak force, and the real peak force can be higher than the estimate. The tool makes no frame, grip, extensometer or fixture recommendation and no statement about accuracy at low load. The page also prints a test force measuring range expressed as a percentage of full scale (0.4% to 100% FS); a printed range is not by itself a statement of accuracy at its lower end, so ask what applies at the forces you will use. Load-cell capacities are the values on the Polytevo Series Universal Testing Machine page (page snapshot 15 November 2026), and not every capacity is offered with every frame; configurations are confirmed on the quotation. Nothing you enter is stored or sent.
ACS Material LLC. Illustrative arithmetic tool.